Marshfield, Missouri · Since 1970
Precision metal finishing,
plated to last.
CaMyer Electroplating has protected and finished parts for manufacturers across the region for more than five decades: zinc, tin, black oxide and more, done right and delivered on time.
- EPA-approved effluent pretreatment
- Hexavalent & trivalent zinc
- Family owned & operated
What we do
Finishing services built for production
From a single prototype to full production runs, every part gets cleaned, plated and inspected to your print.
Zinc Plating
Blue bright, clear and yellow zinc in hexavalent and trivalent chemistries for durable corrosion protection.
Learn moreTin Plating
Solderable, conductive tin for electrical components, connectors and bus bars.
Learn moreBlack Oxide
A deep, uniform black finish for steel with minimal dimensional change and reduced glare.
Learn morePassivation & Cleaning
Chemical cleaning and passivation that removes contamination and boosts corrosion resistance.
Learn moreHeat Treatment
Controlled baking and heat treatment, including hydrogen embrittlement relief after plating.
Learn moreThickness Testing
Plating thickness verification with documentation to support your quality requirements.
Learn more
Plated to spec
Every thread. Every edge. Covered.
Even, consistent coverage, from the head to the last thread.
Finish library
Pick your finish
Move your cursor across a swatch to see how each finish catches the light.
Inside the line
Where the finish happens
Parts hang from rack bars into the plating bath while direct current drives metal out of solution and onto every surface. It's careful, hands-on work, and it's the heart of what we do.
- Parts are cleaned and activated before they ever reach the plating tank
- Agitated baths keep fresh solution moving across every surface
- Rinsed, sealed and dried, then inspected before they ship
How it works
Five steps from rack to ship
Every job runs through a disciplined, documented process.
-
01
Quote
Send prints, specs or a sample part. We’ll return a free estimate.
-
02
Clean & prep
Parts are degreased, cleaned and activated for a perfect bond.
-
03
Plate
DC current deposits an even metal layer in a controlled bath.
-
04
Seal & treat
Chromate, passivation or baking, as your spec calls for.
-
05
Test & ship
Thickness is checked and documented, then parts ship on time.
Environmental commitment
Clean finishes. Clean water.
We take care of the Ozarks we call home. Every gallon of rinse water and spent solution is treated on site before it leaves our facility.
- Compliant with federal, state and local effluent pretreatment regulations
- All process water and solutions run through our EPA-approved pretreatment system
- Precipitated by-products are handled and shipped the right way
- A safe, businesslike operation that protects the natural resources around us
Let’s talk about your next run.
Send us your prints with certification requirements, or a sample part, and we’ll get back to you with a free cost estimate.